If the router is in its default AT&T setup the address will be 192.168.1.254.Default Gateway: This is the IP address of your AT&T U-verse router.The range is as follows: 192.168.1.20 – 192.168.1.40(the 192.168.1 portion will always remain the same simply use the last number of your choice. On the AT&T U-verse router in its default configuration (which 99% are) a certain range of IP addresses can be used.IP Address: This will is the address you will assign to the camera.There are 4 values on the TCP/IP setup page below that we need to enter. The address of your camera needs to stay the same for this process so we are going to change this dynamic IP address to a static (or fixed) IP address. When you setup your WiFi Baby camera using the 10 Step guide your camera was assigned a dynamic (or changing) IP address.In this guide we will demonstrate how to place a rule in your router that will allow your access to the camera through that firewall. The AT&T U-verse routers are in addition a firewall, so they will block all attempts to access your camera from outside your home network. There are some additional steps needed to allow access to your camera from outside you home WiFi Network.

Before starting the steps in this guide please follow our 10 Step Quick Start Guide for the basic setup of your WiFi Baby.ĪT&T U-verse 2Wire routers are not UPnP “Universal Plug and Play” capable devices. This guide will show AT&T U-verse customers how to set up access to your WiFi Baby camera from OUTSIDE of your home WiFi network.

At&t router configuration